| 螺杆空压机重要配件的正确保养与维护 |
| 添加时间：2022/12/21 14:36:22 浏览次数： |
| 螺杆空压机重要配件的正确保养与维护 Correct maintenance of important accessories of screw air compressor 一、进气空滤芯的维护与保养 1、 Maintenance of air inlet filter element 图片 picture 空气滤清器是滤除空气尘埃污物的部件，过滤后的干净空气进入螺杆转子压缩腔压缩。因螺杆机内部间隙只允许15u以内的颗粒滤出。如果空滤芯堵塞破损，大量大于15u的颗粒物进入螺杆机内循环，不仅大大缩短机油滤芯、油细分离芯的使用寿命，还会导致大量颗粒物直接进入轴承腔，加速轴承磨损使转子间隙增大，压缩效率降低，甚至转子枯燥咬死。 The air filter is a part for filtering air dust and dirt. The filtered clean air enters the screw rotor compression chamber for compression. Because the internal clearance of the screw machine is only allowed to filter out particles within 15u. If the air filter element is blocked and damaged, a large number of particles larger than 15u will enter the screw machine for circulation, which will not only greatly shorten the service life of the oil filter element and the oil fine separation core, but also lead to a large number of particles directly entering the bearing cavity, accelerating the bearing wear, increasing the rotor clearance, reducing the compression efficiency, and even killing the rotor. 空滤芯最好每星期保养一次，拧开压盖螺母，取出空滤芯，用0.2-0.4Mpa的压缩空气，从空滤芯内腔向外吹除在空滤芯外表面的尘埃颗粒，用干净的抹布将空滤壳内壁上的赃物擦干净。回装空滤芯，注意空滤芯前端部的密封圈要与空滤壳内端面贴合严密。柴油动力螺杆机的柴油机进气空滤芯的保养应与空压机空滤芯同步进行，保养方法相同。 It is better to maintain the air filter element once a week, unscrew the gland nut, take out the air filter element, use 0.2-0.4Mpa compressed air to blow out the dust particles on the outer surface of the air filter element from the inner cavity of the air filter element, and use a clean rag to clean the dirt on the inner wall of the air filter housing. Reinstall the air filter element. Pay attention that the sealing ring at the front end of the air filter element should closely fit with the inner end face of the air filter housing. The maintenance of the diesel engine inlet air filter element of the diesel powered screw engine shall be carried out simultaneously with the air filter element of the air compressor in the same way. 空滤芯正常情况1000-1500小时更换一次，环境特别恶劣的使用场所，如矿山、陶瓷厂、棉纺厂等，建议每500小时更换空气滤芯。 Under normal conditions, the air filter element should be replaced every 1000-1500 hours. It is recommended to replace the air filter element every 500 hours in places where the environment is particularly harsh, such as mines, ceramics factories, cotton mills, etc. 清洁或更保定网站建设 伺服液位仪 防撞墙模具 唐山护栏 钢纤维 天津除甲醛 保定铝型材换空滤芯时，部件是必须一一合对，严防异物落入进气阀。 When cleaning or replacing the air filter element, the components must be matched one by one to prevent foreign matters from falling into the inlet valve. 平时须经常检查进气伸缩管有无破损、吸扁，伸缩管与空滤进气阀的连接口有无松动、漏气。如发现须及时修复、更换。 At ordinary times, it is necessary to regularly check whether the air inlet expansion pipe is damaged or flat, and whether the connection port between the expansion pipe and the air filter inlet valve is loose or leaking. If found, it shall be repaired and replaced in time |
| 上一页 没有了 |
| 下一页 空压机常见故障问题 |
Copyright © 技术支持：遨游网络