| 空压机常见故障问题 |
| 添加时间：2022/11/17 16:01:05 浏览次数： |
| 空压机常见故障问题 Common faults of air compressor (1)环境通风散热状况不良。空压机周围环境影响散热主要有三种情况：一是离墙类障碍物过近;二是空压机附近有其他热源，三是运行时前门及边门敞开，风扇无法形成强气流。 (1) Poor ventilation and heat dissipation of the environment. The environment around the air compressor mainly affects the heat dissipation in three cases: first, it is too close to wall obstacles; Second, there are other heat sources near the air compressor. Third, the front door and side door are open during operation, and the fan cannot form strong airflow. (2)散热器堵塞。当空压机周定州苗木 保定网站建设 保定电动门 保定空压机 化粪池模具 微型蠕动泵 上海起帆电缆围环境灰尘较多时，长期运行就造成散热器外表黏附一层粉尘或油泥，其内部铜管也容易因油垢积累而堵塞，从而影响散热效果。 (2) The radiator is blocked. When there is a lot of dust around the air compressor, long-term operation will cause a layer of dust or oil sludge to adhere to the outside of the radiator, and its internal copper pipe is also easy to be blocked due to the accumulation of oil dirt, thus affecting the heat dissipation effect. (3)滤油器太脏。该机有3个并排的滤油器，当其太脏时因阻力油无法按正常流量进入压缩机，压缩机会因冷却润油不足而迅速升温。当进出油压差超过0.18MPa时就需更换滤芯。 (3) The oil filter is too dirty. The machine has three side-by-side oil filters. When it is too dirty, the resistance oil cannot enter the compressor according to the normal flow, and the compressor will rise rapidly due to insufficient cooling lubricating oil. When the inlet and outlet oil pressure difference exceeds 0.18mpa, the filter element needs to be replaced. (4)冷却油油面过低。当冷机检查时，油面低于检视管下端时应立即进行补充。 (4) The cooling oil level is too low. When the oil level is lower than the lower end of the inspection pipe during the cold machine inspection, it shall be supplemented immediately. (5)油标号低或油质差。该机采用生产厂商的专用压缩机油，用其他低标号或劣质油时会回黏度及比热达不到标准造成温度过高。 (5) Low oil grade or poor oil quality. The machine adopts the manufacturer's special compressor oil. When using other low-grade or inferior oil, the viscosity and specific heat will not reach the standard, resulting in too high temperature. |
| 上一页 螺杆空压机重要配件的正确保养与维护 |
| 下一页 空压机的保养与维修需要注意什么 |
Copyright © 技术支持：遨游网络